LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 289 (Programming And Setup - All Systems) >> Repair Instructions >> Body Control Module Programming & Setup >> Introduction

Body Control Module Programming & Setup: Introduction

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

All the procedures below are designed to set-up a new body control module (BCM) correctly during BCM related service. Some of the procedures may need to be performed separately when replacing other modules or components. Before you start, read these procedures carefully and completely.

IMPORTANT: The following procedures must be followed:
  1. Programming the BCM
  2. Programming Theft Deterrent System Components, if equipped with Passlock System
  3. Relearn Restraints ID
scientia non olet · About LEMON Manuals