LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Video Player Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ensuring Bracket Locating Tabs Are Fully Seated To Roof Bow
    GM792150Courtesy of GENERAL MOTORS CORP.
  1. Carefully install the bracket to the vehicle through the headliner opening, ensuring the locating tabs (1) are fully seated to the roof bow.
    2. Fig 2: View Of Front Bracket Retaining Bolts
    GM778730Courtesy of GENERAL MOTORS CORP.
  2. Partially install the front bracket retaining bolts.
    3. Fig 3: Exposing Rear Bracket Retaining Bolt
    GM792151Courtesy of GENERAL MOTORS CORP.
  3. Carefully pull down on the rearward edge of the headliner in order to expose the rear bolt installation area.
  4. Partially install the rear bracket retaining bolt.
    5. NOTE: Refer to Fastener Notice .
  5. Fully seat the retaining bolts.

    Tighten:  Tighten the bolts to 10 N.m (88 lb in).

    6. Fig 4: Identifying Rear Overhead Console Carrier Screws
    GM792148Courtesy of GENERAL MOTORS CORP.
  6. Install the two rear overhead console carrier screws (1).

    Tighten:  Tighten the screws to 1.2 N.m (10 lb in).

  7. Install the video display assembly. Refer to Video Display Replacement (With Sunroof)  or Video Display Replacement (Without Sunroof) .
  8. Verify the video display for proper operation.
  9. Close the video display screen.
  10. Install the bolt cover bezel.
scientia non olet · About LEMON Manuals