Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fold and tumble the right rear seat to a cargo position.
Leaving the electrical connectors attached, remove the communication interface module from the vehicle communication interface module (VCIM) bracket. Refer to Communication Interface Module Replacement (TrailBlazer, Envoy) .

Fig 1: Locating Retaining Tab On VCIM Bracket

Courtesy of GENERAL MOTORS CORP.

Using a flat bladed tool, release the retaining tab (1) on the VCIM bracket.
Slide the VCIM bracket rearward until the retaining tabs are released from the seat bracket.
Remove the VCIM bracket from vehicle.

Fig 2: Sliding VCIM Bracket To Seat Bracket

Courtesy of GENERAL MOTORS CORP.

Slide the VCIM bracket rearward until the retaining tabs are released from the seat bracket.
Remove the VCIM bracket from vehicle.