LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Cellular System, Entertainment System, And Navigation System >> Repair Instructions >> Radio Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Rear Alignment Locator
    GM718020Courtesy of GENERAL MOTORS CORP.
  1. Position the radio to the I/P.
  2. Connect the electrical connectors to the radio.
  3. Connect the radio antenna cable to the radio.
  4. Position the radio rear alignment locator (1) into the I/P substrate.
    5. NOTE: Refer to Fastener Notice .
  5. Install the 3 screws that retain the radio to the I/P.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  6. Install the accessory trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement (Chevrolet) or Instrument Panel Cluster Trim Plate Bezel Replacement (GMC, Buick) or Instrument Panel Accessory Trim Plate Replacement (Buick) or Instrument Panel Accessory Trim Plate Replacement (GMC) .
  7. Install the lower closeout/insulator panel (GMC only). Refer to Instrument Panel Insulator Panel Replacement (GMC/Chevrolet) .
  8. If a replacement radio is installed, setup the radio. Refer to Control Module References .
scientia non olet · About LEMON Manuals