LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 439 (Cellular System, Entertainment System & Navigation System) >> Repair Instructions >> Communication Interface Module Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Envoy and 2009 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Processor Bracket Retaining Nut
    GM742195Courtesy of GENERAL MOTORS CORP.
  1. Install the processor bracket to the rear seat studs.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the nut to the rear seat back stud.

    Tighten:  Tighten the nut to 45 N.m (33 lb ft).

    3. Fig 2: View Of Retaining Tab On Upper Navigation Control Processor Bracket
    GM741626Courtesy of GENERAL MOTORS CORP.
  3. Position the upper bracket to the processor bracket.
  4. Slide the upper bracket outboard until all the retaining tabs are seated to the processor bracket.
  5. Install the communication interface module. Refer to Communication Interface Module Replacement (TrailBlazer, Envoy) .
  6. Install the right rear seat cushion. Refer to Rear Seat Cushion Replacement .
scientia non olet · About LEMON Manuals