LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 355 (Cellular System, Entertainment System, And Navigation System) >> Diagnostic Information and Procedures >> Audio/Video Disc Player Adapter - Audio or Video Inoperative or Degraded Quality >> Circuit/System Testing >> Auxiliary Audio Malfunction

Auxiliary Audio Malfunction

WARNING: This page is about a different car, the 2008 Pontiac Torrent and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X3 harness connector at the radio.
  2. Ignition ON, verify that a test lamp does not illuminate between B+ and the left auxiliary audio signal circuit terminal 1.
    • If the test lamp illuminates, test the signal circuit for a short to ground. If the circuit tests normal, replace the audio/video adapter.
  3. Ignition ON, verify that a test lamp does not illuminate between B+ and the right auxiliary audio signal circuit terminal 2.
    • If the test lamp illuminates, test the signal circuit for a short to ground. If the circuit tests normal, replace the audio/video adapter.
  4. Verify that a test lamp does not illuminate between the left auxiliary audio signal circuit terminal 1 and ground.
    • If the test lamp illuminates, test the signal circuit for a short to voltage. If the circuit tests normal, replace the audio/video adapter.
  5. Verify that a test lamp does not illuminate between the left auxiliary audio signal circuit terminal 2 and ground.
    • If the test lamp illuminates, test the signal circuit for a short to voltage. If the circuit tests normal, replace the audio/video adapter.
  6. Ignition OFF, test for less than 1 ohm between the left auxiliary audio signal circuit terminal 1 and the audio jack terminal (white).
    • If greater than the specified range, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the audio/video adapter.
  7. Ignition OFF, test for less than 1 ohm between the right auxiliary audio signal circuit terminal 2 and the audio jack terminal (red).
    • If greater than the specified range, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the audio/video adapter.
  8. Ignition OFF, test for less than 1 ohm between the drain wire circuit terminal 9 and ground.
    • If greater than the specified range, test the drain wire circuit for an open/high resistance. If the circuit tests normal, replace the audio/video adapter.
  9. If all circuits test normal, replace the radio.
scientia non olet · About LEMON Manuals