LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 326 (Front Drive Axle) >> Repair Instructions >> Front Axle Lubricant Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drain Plug & Washer
    GM748021Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the drain plug and the washer.

    Tighten:  Tighten the drain plug to 32 N.m (24 lb ft).

  2. Fill the differential carrier assembly with lubricant. Use the proper fluid. Refer to Approximate Fluid Capacities and Fluid and Lubricant Recommendations .
    3. Fig 2: View Of Front Axle Fill Plug
    GM748025Courtesy of GENERAL MOTORS CORP.
  3. Install the fill plug.

    Tighten:  Tighten the fill plug to 32 N.m (24 lb ft).

  4. Install the engine protection shield. Refer to Engine Protection Shield Replacement .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals