LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 326 (Front Drive Axle) >> Repair Instructions >> Differential Carrier Assembly Final Assembly >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the alignment mark between the differential bearing adjuster and the differential carrier assembly case. If the line between the differential bearing adjuster and the differential carrier assembly case is not aligned, re-align the 2 components as necessary.
    2. Fig 1: Identifying Special Tools J 45225 & J 8092
    GM782727Courtesy of GENERAL MOTORS CORP.
  2. Install the left side inner shaft seal using the J 45225  (2) and the J 8092  (1). See Special Tools .
    3. Fig 2: Identifying Axle Seal Installer & Universal Driver Handle (Right)
    GM782610Courtesy of GENERAL MOTORS CORP.
  3. Install the right side inner shaft seal using the J 45225  (2) and the J 8092  (1). See Special Tools .
    4. NOTE: Refer to Component Fastener Tightening Notice .
  4. Install the drain plug.

    Tighten:  Tighten the drain plug to 32 N.m (24 lb ft).

  5. Install the fill plug.

    Tighten:  Tighten the fill plug to 32 N.m (24 lb ft).

scientia non olet · About LEMON Manuals