LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 296 (Disc Brake System) >> Repair Instructions >> Front Disc Brake Hardware Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Caliper Bracket Bushings
    GM788344Courtesy of GENERAL MOTORS CORP.
  1. Install the guide pin bushing on the brake caliper mounting bracket.
    2. Fig 2: View Of Brake Caliper Guide Pin
    GM156329Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Install the solid steel pin in the leading position and the rubber bushed pin in the trailing position.
  2. Install the guide pins in the brake caliper mounting bracket.
  3. Apply high temperature silicone brake lubricant to the brake caliper guide pins. DO NOT apply lubricant to the brake pad hardware or retaining clips.
    4. Fig 3: Identifying Brake Caliper Mounting Bracket
    GM748561Courtesy of GENERAL MOTORS CORP.
  4. Install the brake caliper mounting bracket.
    5. Fig 4: View of Caliper Mounting
    GM777313Courtesy of GENERAL MOTORS CORP.
  5. Install the brake caliper mounting bracket bolts. Lower bolt shown.
  6. Install the brake pad retaining clips to the brake caliper mounting bracket.
    7. Fig 5: View Of Rotor & Caliper
    GM788768Courtesy of GENERAL MOTORS CORP.
  7. Install the brake caliper assembly. Refer to Front Brake Caliper Replacement .
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
scientia non olet · About LEMON Manuals