LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 276 (Sunroof System) >> Repair Instructions >> Sunroof Module Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the sunroof sunshade panel to the sunroof module assembly. Refer to Sunroof Sunshade Replacement .
  2. Install the sunroof window to the sunroof module assembly. Refer to Sunroof Window Replacement .
  3. Install the sunroof motor/actuator to the sunroof module assembly. Refer to Sunroof Motor/Actuator Replacement .
    4. Fig 1: Identifying Sunroof Module Assembly
    GM749611Courtesy of GENERAL MOTORS CORP.
  4. Position the sunroof module assembly to the vehicle with an assistant.
    5. NOTE: Refer to Fastener Notice .
  5. Install the bolts that retain the sunroof module assembly to the roof panel.

    Tighten:  Tighten the bolts to 10 N.m (7 lb ft).

  6. Connect the drain hoses to the sunroof module assembly. Refer to the following procedures:
    7. Fig 2: View Of Sunroof Assembly Electrical Connector
    GM749612Courtesy of GENERAL MOTORS CORP.
  7. Connect the sunroof harness electrical connector.
  8. Install the headliner. Refer to Headlining Trim Panel Replacement .
scientia non olet · About LEMON Manuals