LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 4.2L - Introduction (2 Of 2) >> Repair Instructions >> Knock Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Locating Knock Sensor Components
    GM727528Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to COMPONENT FASTENER TIGHTENING NOTICE .
  1. Install the knock sensor (1 or 2) and the bolt (3).

    Tighten:  Tighten the sensor to 25 N.m (18 lb ft).

  2. Connect the knock sensor harness connector (4).
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals