LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2005 >> Ascender Limited, RWD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> Seat Back Frame Replacement - Front >> Installation Procedure

Installation Procedure

    Fig 1: SIR Wiring Harness, Clips And Lumbar Wiring Harness
    GM753527Courtesy of GENERAL MOTORS CORP.
  1. Install the wiring harness clips (2) to the seat back frame.
  2. Install the lumbar wiring harness (3) to the seat back frame.
  3. Install the SIR wiring harness (1) to the seat back frame.
    4. Fig 2: Side Impact Module Tub Push Pins
    GM753530Courtesy of GENERAL MOTORS CORP.
  4. Install the side impact module tub to the seat back frame with 2 push pins (1).
    5. Fig 3: Inflatable Side Impact Module Screw
    GM753528Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the inflatable side impact module to the seat back frame with 2 screws (1).

    Tighten:  Tighten the side impact module screws to 9 N.m (80 lb in).

  6. Install the seat belt and retractor assembly. Refer to Seat Belt Replacement - Front .
  7. Install the lumbar assembly. Refer to Lumbar Replacement - Front Seat .
  8. Install the front seat back panel. Refer to Seat Back Panel Replacement - Front .
  9. Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front .
  10. Install the front seat back. Refer to Seat Back Replacement - Front .
  11. Install the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
  12. Install the seat assembly to the vehicle. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals