LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2005 >> Ascender LS, 4.2 S, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 5.3L - Introduction) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Top Of Engine Wiring Harness View
    GM898326Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (3).
    2. Fig 2: MAP Sensor
    GM1509706Courtesy of GENERAL MOTORS CORP.
  2. Remove the MAP sensor retaining clip (2) from the intake manifold.
  3. Remove the MAP sensor (1) from the intake manifold.
scientia non olet · About LEMON Manuals