Power Steering Unit: Removal: Notes

1. Remove the stone guard.
2. Remove the transfer gear assembly and universal joint assembly.

   Make a setting mark across the coupling flange and steering unit to ensure reassembly of the parts in the original position.

3. Drain power steering fluid.
4. Remove the tie rod end assembly from knuckle.

   Use tie rod end remover J-29107.

   Fig 1: Removing Tie Rod End Assembly From Knuckle

   Courtesy of ISUZU MOTOR CO.
5. Disconnect the feed line and return line from steering unit.

Remove the clips on the crossmember and frame.

Wire the power steering line to frame.

Fig 2: Disconnecting The Feed Line & Return Line From Steering Unit

Courtesy of ISUZU MOTOR CO.