LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2004 >> Rodeo 3.2 W, 4WD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Security And Locks) >> Front Door Lock Assembly >> Removal

Front Door Lock Assembly: Removal

WARNING: This page is about a different car, the 2004 Isuzu Axiom. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable.
  2. Remove the pull box.
    • Remove the one fixing screw.
    Fig 1: Removing Fixing Screw
    G02788249Courtesy of ISUZU MOTOR CO.
  3. Remove the power window switch (1).
    • Pry the power window switch and remove the connector.
    Fig 2: Removing Driver's Side Power Window Switch
    G02788250Courtesy of ISUZU MOTOR CO.
  4. Remove the inside handle.
    • Open the screw corer (1) and remove the screw.
    • Disconnect the cable.
    Fig 3: Removing Inside Handle
    G02788251Courtesy of ISUZU MOTOR CO.
  5. Remove the door mirror cover.
  6. Pull the door trim panel at the 8 clip positions (1).
    • Disconnect the courtesy light and tweeter harness connectors.
    Fig 4: Pulling Door Trim Panel At 8 Clip Positions
    G02788252Courtesy of ISUZU MOTOR CO.
  7. Remove the pull box bracket.
  8. Remove the inside lock bracket.
    • Disconnect the cable.
  9. Remove the waterproof sheet.
    • Taking notice of the door harness, peel the waterproof sheet off the door panel carefully.
  10. Raise the glass up to the uppermost position.
  11. Remove the door lock assembly.
    • Disconnect the locking links and harness connector.
    • Remove the 3 fixing Torx screws and bolt.
    Fig 5: Removing Door Lock Assembly
    G02788253Courtesy of ISUZU MOTOR CO.
scientia non olet · About LEMON Manuals