LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2004 >> Rodeo 3.2 W, 4WD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Anti-Lock Brake System) >> Front Wheel Speed Sensor (2WD Model) >> Installation

Front Wheel Speed Sensor (2WD Model): Installation

WARNING: This page is about a different car, the 2004 Isuzu Axiom. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the area of the hub that contacts the speed sensor.
  2. Apply silicone gasket sealer (Isuzu P/N 2-90067-800-0) around the flange surface.
    NOTE: Do not allow excess silicone and/or debris to enter the sensor housing.
    Fig 1: Applying Silicone Gasket Sealer Around Flange Surface
    G02787900Courtesy of ISUZU MOTOR CO.
  3. Alignment of the speed sensor connector and hub unit is required. Refer to Fig 2 .
    Fig 2: Aligning Speed Sensor Connector & Hub Unit
    G02787901Courtesy of ISUZU MOTOR CO.
  4. Place the hub assembly (1) and speed sensor (2) face down on Bearing Remover (J-39825). Using a hydraulic press, press until the hub and speed sensor are fully mated, applying pressure no more than 3 lbs (1500 kgf).
    NOTE: To avoid speed sensor breakage Do not use excessive force when pressing the sensor into place.
    Fig 3: Placing Hub Assembly & Speed Sensor On Bearing Remover
    G02787902Courtesy of ISUZU MOTOR CO.
  5. Install the front hub unit assembly to the knuckle. Refer to the workshop manual.
scientia non olet · About LEMON Manuals