LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2004 >> Axiom Base, RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Diagnostic Information & Procedures >> On Vehicle Service >> Throttle Position (TP) Sensor >> Removal Procedure

Removal Procedure

  1. Disconnect the negative battery cable.
  2. Disconnect the TPS electrical connector.
  3. Remove the bolts and the TP sensor from the throttle body.
Fig 1: Removing Bolts And TP Sensor From Throttle Body
G02788890Courtesy of ISUZU MOTOR CO.
NOTE: Do not clean the TP sensor by soaking it in solvent. The sensor will be damaged as a result.
scientia non olet · About LEMON Manuals