LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2004 >> Axiom Base, 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Diagnostic Information & Procedures >> On Vehicle Service >> EVAP Canister >> Installation Procedure

Installation Procedure

  1. Slide the canister into mounting bracket and install the mounting bracket bolt.
  2. Install the retaining bolts the EVAP canister to the mounting bracket on the cross member.
  3. Connect the fuel vapor connector to the EVAP canister vent solenoid.
  4. Connect the two hoses to the EVAP canister.
    Fig 1: Connecting Hoses To Evap Canister
    G02788933Courtesy of ISUZU MOTOR CO.
  5. Disconnect the negative battery cable.
scientia non olet · About LEMON Manuals