LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2004 >> Ascender S, 4WD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission, 4L60-E/4L65-E (Introduction) >> Repair Instructions >> Manual Detent Spring Installation

Manual Detent Spring Installation

    Fig 1: Removing/Installing Manual Detent Spring Assembly
    GM13263Courtesy of GENERAL MOTORS CORP.
  1. Inspect the manual detent spring assembly (63) for cracks or damage.
  2. Install the manual detent spring assembly (63).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the manual detent spring bolt (64).

    Tighten:  Tighten the bolt to 20-27 N.m (15-20 ft. lb.).

scientia non olet · About LEMON Manuals