LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2004 >> Ascender S, 4WD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission, 4L60-E/4L65-E (Introduction) >> Repair Instructions >> Heat Shield Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Transmission Heat Shield Bolts & Shield
    GM394459Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission heat shield to the transmission.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the two bolts securing the transmission heat shield to the transmission.

    Tighten:  Tighten the bolts to 17 N.m (13 ft. lb.).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals