LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2003 >> Rodeo S, 2.2 D, Standard >> Repair and Diagnosis >> Steering >> Power Steering >> Power-Assisted Steering System >> Steering Wheel >> Installation

Steering Wheel: Installation

  1. Install steering switch, then connector the connector to steering switch.
  2. Install steering wheel by aligning the setting marks made when removing.
    CAUTION: Never apply force to the steering wheel shaft using a hammer or other impact tools in an attempt to remove the steering wheel. The steering shaft is designed as an energy absorbing unit.
  3. Tighten the steering wheel fixing nut to the specified torque.

    Torque:  34 N.m (25 lb ft)

  4. Connect horn and steering switch connector.
  5. Support the module and carefully connect the SRS connector.
    NOTE: Pass the lead wire through the tabs on the plastic cover (wire protector) of inflator to prevent lead wire from being pinched.
  6. Tighten bolts to specified torque.

    Torque:  9 N.m (78 lb in)

  7. Connect the yellow SRS connector located under the steering column.
  8. Connect the battery "-" terminal cable.
  9. Turn the ignition switch to the "ON" position and observe the warning light. The lamp should flash 7 times. If the lamp does not operate correctly, refer to AIR BAG RESTRAINT SYSTEMS .
scientia non olet · About LEMON Manuals