Clutch Control: Installation: Bleeding

WARNING: This page is about a different variant/trim than selected.

Check the level of clutch fluid in the reservoir and replenish if necessary.

Fig 1: Checking Level Of Clutch Fluid
Courtesy of ISUZU MOTOR CO.
Bleeding the slave cylinder.
1. Remove the rubber cap from the bleeder screw and wipe clean the bleeder screw. Connect a vinyl tube to the bleeder screw and insert the other end of the vinyl tube into a transparent container.
2. Pump the clutch pedal repeatedly and hold it depressed.
  
  Fig 2: Pumping Clutch Pedal Repeatedly
  Courtesy of ISUZU MOTOR CO.
3. Loosen the bleeder screw to release clutch fluid with air bubbles into the container, then tighten the bleeder screw immediately.
4. Release the clutch pedal carefully. Repeat the above operation until air bubbles disappear from the clutch fluid being pumped out into the container. During the bleeding operation, keep the clutch fluid reservoir filled to the specified level. Reinstall the rubber cap.