Circuit Description
- The range switch supplies the Powertrain Control Module (PCM) with information regarding the selector lever position: P, R, N, D, 3, 2 or L. The selector lever position is indicated by the state of four ON/OFF contacts. The range switch is located on one side of the transmission. It is on the transmission manual shaft and is fixed to the main case.
- The range switch is also used to provide the information P or N to the engine crank wiring. The engine can be cranked only if connector E-41 terminal 4(H) is connected to terminal 1 (E) which is connected to ground.
- The range switch is also used to provide the back up lamp power in reverse. This is the reason why the mode switch is supplied through a 15A fuse (TURN, BACK UP). This fuse can burn due to a short circuit in the back up lamp.
- This DTC detects an invalid state of the range switch or the range switch circuit by deciphering the range switch inputs. This is a type "D" DTC.