Removal & Installation (Rodeo & Rodeo Sport 2.2L)

1. Disconnect negative battery cable.
2. Drain cooling system.
3. Disconnect air cleaner duct from throttle body.
4. Disconnect accelerator cable from throttle lever. See Fig 1 .
5. Disconnect TP sensor and IAC valve electrical connectors.
6. Disconnect vacuum hoses below air horn.
7. Disconnect coolant lines.
8. Remove 4 throttle body-to-intake manifold bolts and remove throttle body from manifold. If replacing throttle body remove TP sensor and IAC valve from throttle body.
9. To install, reverse removal procedure. Replace gaskets as necessary. Tighten bolts to specification. See TORQUE SPECIFICATIONS  .

Fig 1: Locating Throttle Body (Rodeo & Rodeo Sport 2.2L)

Courtesy of ISUZU MOTOR CO.