LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2003 >> Ascender 5.3 P, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Cellular Communication System) >> Repair Instructions >> Navigation Control Processor Bracket Replacement (SWB) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Isuzu Ascender. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Processor Bracket Retaining Nut
    GM742195Courtesy of GENERAL MOTORS CORP.
  1. Install the processor bracket to the rear seat studs.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nut to the rear seat back stud.

    Tighten:  Tighten the nut to 45 N.m (33 lb ft).

    3. Fig 2: Releasing Retaining Tab On Upper Bracket
    GM741626Courtesy of GENERAL MOTORS CORP.
  3. Position the upper bracket to the processor bracket.
  4. Slide the upper bracket outboard until all the retaining tabs are seated to the processor bracket.
  5. Install the communication interface module. Refer to Communication Interface Module Replacement (SWB)  or Communication Interface Module Replacement (LWB)  in Interior Trim.
  6. Install the right rear seat cushion. Refer to Seat Cushion Replacement - Rear No. 1 (Short Wheelbase) in Seats.
scientia non olet · About LEMON Manuals