LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2003 >> Ascender 4.2 S, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Entertainment System) >> Repair Instructions >> Radio Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Isuzu Ascender. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Alignment Locator
    GM718020Courtesy of GENERAL MOTORS CORP.
  1. Position the radio to the I/P.
  2. Connect the electrical connectors to the radio.
  3. Connect the radio antenna cable to the radio.
  4. Position the radio rear alignment locator (1) into the I/P substrate.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the 3 screws retaining the radio to the I/P.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  6. Install the accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory in Instrument Panel, Gages and Console.
  7. Install the lower closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower in Instrument Panel, Gages and Console.
  8. Install the center console. Refer to Console Replacement in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals