LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2003 >> Ascender 4.2 S, 4WD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> 3rd Row Seat Inner Riser Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Seat Recliner View
    GM824165Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the two rear seat back mounting bolts (1) securing the inner riser assembly to the seat back frame.

    Tighten:  Tighten the rear seat back mounting bolts to 25 N.m (18 lb ft).

  2. Pull the seat cover back down over the seat pad.
    3. Fig 2: Unhooking the J-strip
    GM824164Courtesy of GENERAL MOTORS CORP.
  3. Secure the seat back cover flaps to the pad with the hog rings (2).
  4. Install the J-strip (1) on the bottom of the seat back cover.
  5. Install the seat adjuster cross bar. Refer to Seat Adjuster Cross Bar Replacement - Rear No. 2 .
  6. Install the seat riser latch assembly. Refer to Seat Riser Latch Assembly Replacement - Rear No. 2 .
  7. Install the seat latch rod. Refer to Seat Latch Rod Replacement - Rear No. 2 .
  8. Install the seat belt buckle assembly.
  9. Install the seat in the vehicle. Refer to Seat Replacement - Rear No. 2 .
scientia non olet · About LEMON Manuals