Diagnostic Check: Notes
WARNING: This page is about a different variant/trim than selected.
This test determines if the transmission or its inputs, outputs, connections, or sensors are failing.
- Connect the Tech 2: GO THROUGH Tech 2 OBD II CONNECTION.
- Turn on the ignition but not the engine.
- Push "F2" on Tech 2 to see the DIAGNOSTIC TROUBLE CODE (DTC) :
- Do you have a DTC?
YES: write down all code numbers and do the DTC CHECK
NO: the DTC can not help you find the problem.
- GO THROUGH "CHECK TRANS" CHECK
- IF it is flashing and the flash is 0.2 seconds ON and 0.2 seconds OFF, this means that you should have a DTC stored. Please recheck GO TO DIAGNOSTIC CHECK and if you find the same problem, replace the Powertrain Control Module (PCM).