Removal & Installation: Starter: Removal

1. Disconnect battery ground cable.
2. Disconnect heated O2 sensor connector (1).
3. Remove exhaust front left pipe (2). See Fig 1 .
4. Remove the heat protector.
5. Disconnect starter wiring connector from terminals (B) and (S) (4).
6. Remove starter assembly mounting bolts on inside and outside (5).
7. Remove starter assembly toward the bottom of engine (6). See Fig 2 .

Fig 1: Removing Exhaust Front Left Pipe

Courtesy of ISUZU MOTOR CO.

Fig 2: Removing Starter Assembly

Courtesy of ISUZU MOTOR CO.