LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2002 >> Rodeo Sport 2.2 D, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Power-Assisted Steering System) >> Inflator Module >> Installation

Inflator Module: Installation

WARNING: This page is about a different car, the 2002 Isuzu Rodeo and 2002 Honda Passport. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install inflator module.
  2. Support the module and carefully connect the module connector and horn lead.
    NOTE: Pass the lead wire through the tabs on the plastic cover (wire protector) of inflator to prevent lead wire from being pinched.
  3. Tighten bolts to specified torque.

    Torque:  9 N.m (78 lb in)

  4. Connect the yellow 2-way SRS connector located under the steering column.
  5. Connect the battery ground cable.
  6. Set ignition to "ON" while watching warning light. Light should flash 7 times and then go off. If lamp does not operate correctly, refer to AIR BAG RESTRAINT SYSTEMS .
scientia non olet · About LEMON Manuals