Transfer Case
- Service Precaution
- General Description
- Transfer Rear Oil Seal
- Transfer Case Assembly
- Transfer Control Unit
- Transfer Disassembly
- Main Data and Specifications
- Transfer Case Control System
- Transfer Controller
- Notes
- Removal
- Installation
- Function of Switch and Indicator Lamp
- 2H to 4H Retrial
- Parts Location
- Circuit Diagram
- Connector List
- Diagnosis
- Diagnosis From Symptom
- Check 4WD Lighting Up
- Cannot shift from 2WD to 4H or 4L. When shifting from 2H to other position, the indicator (4WD, 4Lo, Check 4WD) does not respond.
- Even after correction step 1-1(Before determining a trouble (Non-trouble mode)), the 4WD indicator still blinks at 2Hz and clicking sound of relay continues.
- Even after the correction step 1-2(Before determining a trouble (Non-trouble mode)), the 4WD indicator still blinks at 2Hz when shifting with clicking sound of relay from 2H to 4H.
- After operation, indicator of target position blinks for 1.5 sec. at 2Hz, return to 2H condition (4WD indicator going out)
- Transfer cannot shift to a position other than 4H. When shifting from 4H to other position, indicator (4WD, 4Lo, Check 4WD) does not respond (Only 4WD keeps lighting).
- Even after the correction step 2-1(Before determining a trouble (Non-trouble mode)), the 4WD indicator still blinks at 2Hz when shifting from 4H to 2H.
- Though the indicator responds when shifting from 4H to 2H (or other position), it returns to 4H.
- From 4H to 4L; Even after the correction step 3-3(Before determining a trouble (Non-trouble mode)), 4Lo indicator blinks at 4Hz
- From 4L to 4H: After the correction step 4-3(Before determining a trouble (Non-trouble mode)), 4Lo indicator blinks at 4H.