LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2002 >> Rodeo LS, 2.2 D >> Repair and Diagnosis >> Steering >> Steering Column >> Power-Assisted Steering System >> Steering Wheel >> Installation

Steering Wheel: Installation

  1. Install steering wheel by aligning the setting marks made when removing.
    CAUTION: Never apply force to the steering wheel in direction of the shaft by using a hammer or other impact tools in an attempt to remove the steering wheel. The steering shaft is designed as an energy absorbing unit.
  2. Tighten the steering wheel fixing nut to the specified torque.

    Torque:  34 N.m (25 lb ft)

  3. Connect horn lead.
  4. Support the module and carefully connect the SRS connector.
    NOTE: Pass the lead wire through the tabs on the plastic cover (wire protector) of inflator to prevent lead wire from being pinched.
  5. Tighten bolts to specified torque.

    Torque:  9 N.m (78 lb in)

  6. Connect the yellow 2-way SRS connector located under the steering column.
  7. Connect the battery "-" terminal cable.
  8. Turn the ignition switch to "ON" and observe the warning light. Light should flash 7 times. If lamp does not operate correctly, refer to AIR BAG RESTRAINT SYSTEMS .
scientia non olet · About LEMON Manuals