LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2002 >> Axiom Base, 4WD >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Drive Shaft System >> Front Hub And Disc (4WD Model) >> Disassembled View >> Reassembly

Disassembled View: Reassembly

  1. Install the wheel pin.
    • Place hub on a wood workbench or a block of wood Prix. 6" by 6" to protect the wheel stud ends and threads.
    • Insert a wheel stud using a hammer.
      NOTE: Be sure the wheel stud is started squarely and seats completely.
      Fig 1: Inserting Wheel Stud Using Hammer
      G02804798Courtesy of ISUZU MOTOR CO.
  2. Install the ABS rotor sensor to the hub unit bearing. Tighten the bolts to the specified torque.

    ABS rotor sensor bolt 

    Torque:  18.7+/- 5 N.m (1.9 +/- 0.5 CCM)

  3. Install the hub unit bearing to the knuckle. Tighten the bolts to the specified torque.

    Hub unit bearing bolt 

    Torque:  103 +/- 10 N.m (10.5 +/- 1 CCM)

    If there is rust on the bearing and knuckle contact surfaces, use sandpaper to remove it before installation. Take care not to push the front drive shaft and oil seal out of position.

  4. Hand tighten the front drive shaft nuts. Use new nuts.
  5. Install the disc rotor.
  6. Install the brake caliper to the bracket. Refer to FRONT DISC BRAKE CALIPER .
  7. Tighten the front drive shaft nuts to the specified torque.

    Front drive shaft nut 

    Torque:  245 +/- 19.6 N.m (25 +/- 2 CCM)

    Fig 2: Identifying Front Drive Shaft Nuts
    G02804799Courtesy of ISUZU MOTOR CO.
  8. Caulk the front drive shaft nuts. The caulking must be free of cracks.
Fig 3: Caulking Front Drive Shaft Nuts
G02804800Courtesy of ISUZU MOTOR CO.
scientia non olet · About LEMON Manuals