Bleeding Procedure

When bleeding the system, or any time fluid is added to power steering system, be sure to use correct power steering fluid.

1. Fill pump fluid reservoir to proper level and let fluid settle for at least 2 minutes.
2. Start engine and let it run for a few seconds. Do not turn steering wheel. Then, turn engine off.
3. Add fluid if necessary.
4. Repeat above procedure until fluid level remains constant after running the engine.
5. Raise and support front end of vehicle so that wheels are off ground.
6. Start engine, and slowly turn steering wheel right and left, lightly contacting wheel stops.
7. Add power steering fluid if necessary.
8. Lower vehicle, and set steering wheel at straight forward position after turning it to its full steer positions 2 or 3 times, and stop engine.
9. Check fluid level and refill as required.
10. If fluid is extremely foamy, allow vehicle to set a few minutes, then repeat above procedure.