Electronically Erasable Programmable Read Only Memory (EEPROM) Programming

If Vehicle Control Module (VCM) was replaced, the EEPROM in the VCM must be programmed. If EEPROM is not programmed, a Diagnostic Trouble Code (DTC) will be set in the VCM.
Ensure battery is fully charged. Ensure cable is properly connected on Data Link Connector (DLC). Turn ignition on. Perform EEPROM programming using the Techline equipment manufacturer's instructions and latest applicable software for the vehicle.
Once EEPROM has been reprogrammed, Crankshaft Position (CKP) sensor variation learn procedure and password learn procedure must be performed using proper procedure. Once Crankshaft Position (CKP) sensor variation learn procedure and password learn procedure are performed, perform powertrain On-Board Diagnostic (OBD) system check. See POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK in SELF-DIAGNOSTICS - INTRODUCTION article.
NOTE: If EEPROM programming fails, ensure all electrical connections on VCM are okay. Check Techline for latest software. If EEPROM programming still fails, replace VCM.