LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1997 >> Rodeo S, 2.6 E >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls - Remove/Install/Overhaul - 3.2L) >> Fuel System >> Accelerator Cable >> Adjusting Cable At Throttle Body

Adjusting Cable At Throttle Body

WARNING: This page is about a different variant/trim than selected.
  1. Loosen adjusting and jam nuts. Pull on cable while fully closing throttle valve. Tighten adjusting and jam nuts.
  2. Loosen adjusting nut by 3 turns and tighten jam nut again. Valve lever must return up to stopper screw. If valve lever does not reach stopper screw, repeat adjustment procedure.
scientia non olet · About LEMON Manuals