LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1997 >> Rodeo S, 2.6 E >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System - Tests >> Bleeding Brake System >> Bleeding Procedures >> Pressure Tank Bleeding

Pressure Tank Bleeding

  1. Start engine and let idle. Clean master cylinder cap and surrounding area, then remove cap. With pressure tank at least 1/2 full, connect tank to master cylinder using proper adapter(s).
  2. Attach bleed hose to first wheel cylinder or caliper bleed screw to be serviced. Proper brake bleeding sequence is ALV, left rear wheel, right rear wheel, left front wheel, then right front wheel. Place remaining end of hose into clean transparent container. Partially fill container with clean brake fluid until end of hose is submerged.
  3. Open release valve on pressure tank. Open bleed screw, noting fluid flow. When fluid flowing into container is clear and bubble free, close bleed screw securely.
  4. Finish bleeding system in the same manner using correct sequence. Close release valve, and remove pressure tank from master cylinder. Check fluid level of master cylinder reservoir.
scientia non olet · About LEMON Manuals