Power Window Switch Continuity (Passenger Side & Rear)
Remove switch from door trim panel. Disconnect appropriate power window switch harness connector. Using an ohmmeter, check for continuity between specified switch terminals with power window switch in specified position. See POWER WINDOW SWITCH CONTINUITY CHART . For switch terminal identification, seeFigure and Figure . If continuity is not as specified, replace appropriate switch.
POWER WINDOW SWITCH CONTINUITY CHART
| Application & Position | Check Continuity Between Terminals: | |
|---|---|---|
| Power Circuit | ||
| DOWN | 2 & 3 | |
| OFF | N/A | |
| UP | 3 & 4 | |
| Ground Circuit | ||
| DOWN | 4 & 5 | |
| OFF | 1 & 2; 4 & 5 | |
| UP | 1 & 2 | |