LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1992 >> Rodeo LS, 4WD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Testing >> Ignition Checks >> Non-HEI Systems (2.6L Amigo, Pickup, Rodeo) >> Ignition Coil

Ignition Coil

  1. Ensure ignition switch is off. Disconnect ignition coil wiring.
  2. Measure primary resistance between terminals "C" and "E". See Fig 1 . Measure secondary resistance between terminals "C" and "D". Measure insulation resistance between terminals "C" and body ground.
  3. On all models, resistance should be within specification. See IGNITION COIL RESISTANCE (NON-HEI SYSTEMS)  table. Replace coil if resistance is not within specification.
IGNITION COIL RESISTANCE (NON-HEI SYSTEMS) Ohms @ 68°F (20°C)

Application (1) Primary Secondary
Amigo, Pickup & Rodeo 2.6L .81-.99 7500-11,300
(1) On all models, insulation resistance should not be more than 10m (million) ohms.
Fig 1: Identifying Ignition Coil Terminals
G91B16627Courtesy of ISUZU MOTOR CO.
scientia non olet · About LEMON Manuals