LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1992 >> Pickup LS, 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests - EFI >> Engine Sensors & Switches >> Coolant Temperature Sensor

Coolant Temperature Sensor

  1. Unplug coolant temperature sensor. On Amigo, Pickup and Rodeo (2.6L), sensor is located on right side of engine, below intake manifold. Sensor connector contains Black and Green/Yellow wires.
  2. On Trooper, sensor is located on rear of engine, in coolant transfer tube. SOHC is located in driver side of tube and DOHC is located in passenger side of tube. Sensor connector contains Black and Black/Gray wires.
  3. On all models, check resistance between sensor terminals at specified temperature. See COOLANT TEMPERATURE SENSOR RESISTANCE SPECIFICATIONS table. Replace sensor if not within specification.
NOTE: Coolant temperature sensor malfunctions may also set Codes 14 and 15. For additional testing information, see appropriate TESTS W/CODES article in the ENGINE PERFORMANCE Section.
COOLANT TEMPERATURE SENSOR RESISTANCE SPECIFICATIONS

Temperature °F (°C) Ohms
Amigo, Pickup & Rodeo 2.6L
14 (-10) 7000-12,000
50 (10) 3000-5000
68 (20) 2000-3000
122 (50) 700-1000
176 (80) 200-400
Trooper
-40 (-40) 100,700
0 (-18) 25,000
20 (-7) 13,500
40 (4) 7500
70 (21) 3400
100 (38) 1800
160 (71) 450
210 (99) 185
Pickup & Rodeo 3.1L
-40 (-40) 100,700
-22 (-30) 52,700
-4 (-20) 28,680
5 (-15) 21,450
14 (-10) 16,180
23 (-5) 12,300
32 (0) 9420
41 (5) 7280
50 (10) 5670
59 (15) 4450
68 (20) 3520
77 (25) 2796
86 (30) 2238
95 (35) 1802
104 (40) 1459
113 (45) 1188
122 (50) 973
140 (60) 667
158 (70) 467
176 (80) 332
194 (90) 241
212 (100) 177