LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1990 >> Impulse Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Distributor >> Installation (2.3L & 2.6L)

Installation (2.3L & 2.6L)

  1. Remove valve cover. Bring No. 4 cylinder to TDC of compression stroke. Align camshaft pulley set mark with front plate set mark.
  2. Apply engine oil to distributor o-ring. Align distributor case set mark with distributor shaft set mark. See Fig 1 . Install distributor into cylinder head.
  3. Align distributor shaft set mark with cylinder head set mark. See Fig 1 . Install valve cover.
  4. Install and tighten distributor-to-cylinder head bolt to specification. See TORQUE SPECIFICATIONS  .
  5. Connect high tension wires and distributor harness connector. Set ignition timing. See appropriate SPECIFICATIONS article in ENGINE PERFORMANCE section.
Fig 1: Distributor & Cylinder Head Set Marks (2.3L & 2.6L)
G50C17071Courtesy of ISUZU MOTOR CO.
scientia non olet · About LEMON Manuals