LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 1986 >> I-Mark Base, 2D Hatchback, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Evaporation System >> Component Testing >> Canister Purge Control Valve

Canister Purge Control Valve

  1. Remove canister from vehicle. Apply 7.5 psi air pressure to port marked "VC". Air should not leak from diaphragm. See Fig 1 .
  2. Apply and maintain 15 in. Hg vacuum to port marked "PURGE". Gradually apply vacuum to "VC" port. Purge valve should begin to open when 1.6-3.2 in. Hg vacuum is applied to port "VC". Replace valve if it does not operate as outlined.
Fig 1: Testing Purge Control Valve (Except Impulse)
G37913
scientia non olet · About LEMON Manuals