Confirmation Procedure

If the other DTC Confirmation Procedure is performed right before this procedure, the ignition switch must be turned OFF and wait for 10 seconds or more to start this procedure.

>>

GO TO 2.

With CONSULT:

1. Turn ignition switch ON.
2. Select "DATA MONITOR" mode of "ENGINE" With CONSULT:
3. Check that the "BRAKE SW" indication as per the following condition.

   Monitor item	Condition		Indication
   BRAKE SW	Brake pedal	Fully released	OFF
   		Slightly depressed	ON

Without CONSULT

1. Turn ignition switch OFF.
2. Check the stop lamp when depressing and releasing the brake pedal.

   Brake pedal	Stop lamp
   Fully released	Not illuminated
   Slightly depressed	Illuminated

Is the inspection result normal?

YES-1>>

To check malfunction symptom before repair: Refer to Inspection .

YES-2>>

Confirmation after repair: INSPECTION END

NO>>

Refer to DTC Diagnosis Procedure .