Work Procedure

Description 

Perform initial calibration after replacing transfer rotary position sensor.

Work Procedure 

1. INITIAL CALIBRATION 

   With CONSULT

   1. Start the engine.
      CAUTION:

      Never drive the vehicle.

   2. Check "4WD MODE", "T/M RANGE", "COMPR VHCL SPEED", "MOTOR POWER SUP" of CONSULT "DATA MONITOR" for "ALL MODE AWD/4WD".
   3. Continue the following condition.

      4WD MODE	: AUTO
      T/M RANGE	: N
      COMPR VHCL SPEED	: 0 km/h (Never drive the vehicle)
      MOTOR POWER SUP	: More than 11 V

   4. Select "START CALIBRATION" of CONSULT "WORK SUPPORT" for "ALL MODE AWD/4WD".
   5. Wait till the motor operates. (Approx. 10 seconds)

   >>

   GO TO 2.

2. PERFORM SELF-DIAGNOSIS 

   With CONSULT

   1. Erase self-diagnosis result for "ALL MODE AWD/4WD".
   2. Turn the ignition switch ON to OFF.
      CAUTION:

      Wait for 10 seconds after turning ignition switch OFF.

   3. Start the engine.
      CAUTION:

      Never drive the vehicle.

   4. Perform self-diagnosis for "ALL MODE AWD/4WD".

   Is "DTC P180D" detected?

   YES>>

   GO TO 1.

   NO>>

   WORK END