Work Procedure

Description 

• Detect a stroke of transfer lock sleeve and learn operating area of transfer lock sleeve (Lock/Unlock)
• Perform the learning of transfer lock position sensor by "WORK SUPPORT" of CONSULT function.
  CAUTION:

  Before performing the learning of lock position sensor, must erase learning of transfer lock position sensor.

*: "LOCK SLEEVE SENSOR" means transfer lock position sensor.

Work Procedure 

1. PREPARATION BEFORE WORK 

   With CONSULT

   1. Continue the following condition at vehicle.

      Engine	: Running
      Parking brake	: Apply
      Brake pedal	: Release
      Electrical system like air conditioner	: OFF

      CAUTION:

      Never drive the vehicle.

   2. Check "4WD MODE", "T/M RANGE", "COMPR VHCL SPEED", "MOTOR POWER SUP" of CONSULT "DATA MONITOR" for "ALL MODE AWD/4WD".
   3. Continue the following condition.

      4WD MODE	: 4L
      T/M RANGE	: N
      COMPR VHCL SPEED	: 0 km/h (Never drive the vehicle)
      MOTOR POWER SUP	: More than 11 V

   >>

   GO TO 2.

2. PERFORM LOCK POSITION SENOR LEARNING 

   With CONSULT

   1. Select "LOCK SLEEVE SENSOR LEARNING" of CONSULT "WORK SUPPORT" for "ALL MODE AWD/4WD".
   2. Select "Start".
   3. Wait until the motor operation stop.

   Is "Error" detected?

   YES (within 5 times)>>

   GO TO 1.

   YES (over 5 times)>>

   Transfer assembly is mechanical malfunction. Replace transfer assembly Refer to TRANSFER ASSEMBLY : Removal and Installation .

   NO>>

   GO TO 3.

3. PERFORM SELF-DIAGNOSIS 

   With CONSULT

   1. Erase self-diagnosis result for "ALL MODE AWD/4WD".
   2. Turn the ignition switch ON to OFF.
      CAUTION:

      Wait for 10 seconds after turning ignition switch OFF.

   3. Start the engine.
      CAUTION:

      Never drive the vehicle.

   4. Perform self-diagnosis for "ALL MODE AWD/4WD".

   Is "DTC P182B" detected?

   YES>>

   GO TO 1.

   NO>>

   WORK END