Work Procedure

Description 

Perform transfer fluid viscosity learning and initial calibration after draining and refilling transfer fluid.

Work Procedure 

1. PREPARATION BEFORE WORK 

   With CONSULT

   1. Start the engine.
      CAUTION:

      Never drive the vehicle.

   2. Check "4WD MODE", "T/M RANGE", "COMPR VHCL SPEED", "MOTOR POWER SUP" of CONSULT "DATA MONITOR" for "ALL MODE AWD/4WD".
   3. Continue the following condition more than 10 seconds.

      4WD MODE	: AUTO
      T/M RANGE	: N
      COMPR VHCL SPEED	: 0 km/h (Never drive the vehicle)
      MOTOR POWER SUP	: More than 11 V

   >>

   GO TO 2.

2. TRANSFER FLUID VISCOSITY LEARNING 

   With CONSULT

   1. Select "OIL DETERIORATION INFO RESET" of CONSULT "WORK SUPPORT" for "ALL MODE AWD/4WD".
   2. Select "Start".

   >>

   GO TO 3.

3. INITIAL CALIBRATION 

   With CONSULT

   1. Select "START CALIBRATION" of CONSULT "WORK SUPPORT" for "ALL MODE AWD/4WD".
   2. Wait until the motor operation stop. (After approximately 10 seconds)

   >>

   GO TO 4.

4. PERFORM SELF-DIAGNOSIS 

   With CONSULT

   1. Erase self-diagnosis result for "ALL MODE AWD/4WD".
   2. Turn the ignition switch ON to OFF.
      CAUTION:

      Wait for 10 seconds after turning ignition switch OFF.

   3. Start the engine.
      CAUTION:

      Never drive the vehicle.

   4. Perform self-diagnosis for "ALL MODE AWD/4WD".

   Is "DTC P181F" detected?

   YES>>

   GO TO 1.

   NO>>

   WORK END