Consult Function

CONSULT APPLICATION ITEMS

Diagnostic test mode	Function
Work Support	This mode enables a technician to adjust some devices faster and more accurately.
Self Diagnostic Results	Retrieve DTC from ECU and display diagnostic items.
Data Monitor	Monitor the input/output signal of the control unit in real time.
ECU Identification	Display the ECU identification number (part number etc.) of the selected system.
Active Test	Send the drive signal from CONSULT to the actuator. The operation check can be performed.

WORK SUPPORT

CAUTION:

Perform the procedure when the vehicle is stopped.

Item name	Description
STANDARD HEIGHT LEVEL	Forcibly sets vehicle height to the set standard vehicle height.
ADJUST HEIGHT INI	Sets standard vehicle height.
CLEAR HEIGHT INI	Erases standard vehicle height.

SELF DIAGNOSTIC RESULTS

Refer to DTC Index . When "CRNT" is displayed on self-diagnosis result,

The system is presently malfunctioning.

When "PAST" is displayed on self-diagnosis result,

System malfunction in the past is detected, but the system is presently normal.

Freeze frame data (FFD)

Item name	Description
IGN COUNTER	The number of times that ignition switch is turned ON after the DTC is detected is displayed. When "0" is displayed: It indicates that the system is presently malfunctioning. When except "0" is displayed: It indicates that system malfunction in the past is detected, but the system is presently normal. NOTE: Each time when ignition switch is turned OFF to ON, numerical number increases in 1 → 2 → 3..38 → 39. When the operation number of times exceeds 39, the number do not increase and "39" is displayed until self-diagnosis is erased.

Item name

Description

IGN COUNTER

The number of times that ignition switch is turned ON after the DTC is detected is displayed.

When "0" is displayed: It indicates that the system is presently malfunctioning.
When except "0" is displayed: It indicates that system malfunction in the past is detected, but the system is presently normal.
NOTE: Each time when ignition switch is turned OFF to ON, numerical number increases in 1 → 2 → 3..38 → 39. When the operation number of times exceeds 39, the number do not increase and "39" is displayed until self-diagnosis is erased.

DATA MONITOR

NOTE: The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitored item (Unit)		Remarks
IGN VOLT	(V)	Displays the power supply voltage of air levelizer control module.
VHCL HT INTLZ STA		Displays setting status of standard vehicle height.
VHCL HT INIT SLCT		Displays setting status of standard vehicle height.
VHCL HEIGHT SEN	(V)	Displays the signal voltage of vehicle height sensor.
VHCL HT CNVSN VL	(mm)	Displays the vehicle height recognized by air levelizer control module.
VHCL HGT FIX TIME	(hour)	Displays period of time that signal from vehicle height sensor does not change.
VHCL HGT INIT VAL	(V)	Displays voltage when standard vehicle height is set. Value does not change until setting of standard vehicle height is performed again.
COMPRESSOR		Displays operation status of air compressor.
EXH SOLENOID		Displays operation status of exhaust solenoid.
ENG SPEED SIG		Displays operation status of engine.
WARNING LAMP		Displays turning ON status of CK SUSP indicator lamp.

ACTIVE TEST

CAUTION:

Perform the procedure when the vehicle is stopped.
Be careful that battery is not discharged when performing the procedure while engine is stopped.

Item name	Description
COMPRESSOR	Air compressor can be operated.
EXHAUST SOLENOID	Exhaust solenoid of air compressor can be operated.
WARNING LAMP	CK SUSP indicator lamp can be turned ON or OFF.