Component Inspection

1. Turn ignition switch OFF.
2. Remove EVAP control system pressure sensor with its harness connector.

   Always replace O-ring with a new one.

3. Install a vacuum pump to EVAP control system pressure sensor.
4. Turn ignition switch ON and check output voltage between ECM harness connector terminals under the following conditions.

   ECM			Condition [Applied vacuum kPa (kg/cm2 , psi)]	Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   E20	121	148	Not applied	1.8 - 4.8
   			-26.7 (-0.272, -3.87)	2.1 to 2.5 lower than above value

   CAUTION:

   • Always calibrate the vacuum pump gauge when using it.
   • Never apply below -93.3 kPa (-0.952 kg/cm² , -13.53 psi) or pressure over 101.3 kPa (1.033 kg/cm² , 14.69 psi).

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace EVAP control system pressure sensor.