Work Procedure

Memory Storage Procedure 

Two positions for the driver seat, steering column and outside mirror can be stored for memory operation by following procedure:

1. STEP 1 
   1. Check the following conditions:
      • Ignition switch: ON
      • CVT shift selector: P (Park) position

   >>

   GO TO 2.

2. STEP 2 
   1. Adjust driver seat, steering column and outside mirror position manually.

   >>

   GO TO 3.

3. STEP 3 
   1. 1. Push set switch.
         NOTE:

         • Memory indicator for which driver seat position is already retained in memory is illuminated for 5 seconds.
         • Memory indicator for which driver seat position is not retained in memory is illuminated for 0.5 seconds.
      2. Push the memory switch (1 or 2) for at least 1 second within 5 seconds after pushing the set switch.
         NOTE:

         • To enter driver seat positions into blank memory, memory indicator will be turned on for 5 seconds.
         • To modify driver seat positions, memory indicator will be turned OFF for 0.5 seconds, then turned ON for 5 seconds.
         NOTE: If memory is stored in the same memory switch, the previous memory will be deleted.

   >>

   GO TO 4.

4. STEP 4 
   1. Confirm the operation of each part with memory operation.

   >>

   Inspection End.