DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detecting condition
P0340	CMP SEN/CIRC-B1 (Camshaft position sensor "A" circuit bank 1)	The cylinder No. signal is not sent to ECM for the first few seconds during engine cranking. The cylinder No. signal is not sent to ECM during engine running. The cylinder No. signal is not in the normal pattern during engine running.

POSSIBLE CAUSE

Harness or connectors [CMP sensor (bank 1) circuit is open or shorted.]
Camshaft position sensor (bank 1)
Camshaft (INT)
Starter motor
Starting system circuit
Dead (Weak) battery

FAIL-SAFE

NOTE: Any of the following fail-safe is applied.

Fail safe mode	Vehicle behavior
Device fix mode	Fixes electric intake valve timing control motor in the reference position. Fixes exhaust valve timing control solenoid valve in the reference position.
Combustion control mode	No stratified charge combustion at starting (cold start).

Fail safe mode	Vehicle behavior
Device fix mode	Fixes electric intake valve timing control motor in the reference position. Fixes exhaust valve timing control solenoid valve in the reference position.
Combustion control mode	Stops feedback control of idle speed and controls with specified speed. Stops recovery speed control by the fuel cut at decelerating and controls with specified speed.